Microchip LEDコントローラ IC, 410 μA, 275 V (最大) max. 表面実装, 33-Pin QFN

The CL8800 is designed to drive a long string of inexpensive, low current LEDs directly from the AC mains. A basic driver circuit consists of the CL8800, six resistors, and a bridge rectifier. Two to four additional components are optional for various levels of transient protection. No capacitors, EMI filters, or power factor correction circuits are needed. A string of series/parallel LEDs is tapped at six locations. Six linear current regulators sink current at each tap and are sequentially turned on and off, tracking the input sine wave voltage.

Minimal component count (base config: CL8800 + 6 resistors + diode bridge)
No magnetics, no capacitors
Up to 7.5W output (13W w/ heat sink)
>110Lm/W using efficient LEDs
85% typical electrical efficiency
>0.95 power factor
<20% THD line current
Low conducted EMI w/o filters
85% LED luminous utilization
Phase dimmer compatible with an RC network

LEDドライバ、Microchip